Technical information 1K Primer for Zinc
Specifieke additieven zorgen ervoor dat ColorMatic 1K Primer voor Zink een uitstekende hechting en corrosiebescherming biedt, met name voor blank met zink bekleed staal. Dit sneldrogende product is speciaal geformuleerd voor het overspuiten van OEM verzinkte carrosserieën.
Voordat u gaat werken met ColorMatic 1K primer voor zink, het oppervlak behandelen met ColorMatic Siliconenverwijderaar Art. nr. 174469. Voor het beste resultaat raden wij aan de ColorMatic 2K Hi-Speed Primer te gebruiken zodra de 1K primer voor zink is opgedroogd. Daarna kunt u overschilderen met gemengde verven uit onze pre-fill systemen op water- of solventbasis.
Toepassing:
Ideaal voor spot repair en het overspuiten van onderdelen.
Physical and chemical data
- Basis of binder: specific mixture of resin
- Colour: light grey
- Smell: solvent
- Efficiency:
1 m² - Substrate:
bare zinc-coated metal, sanded. Sanded through areas on galvanised substrates - Temperature resistance: to 90°C
- Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) - Size:
Aerosol cans, maximum nominal volume 400 ml - VOC-value: 259,3g
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Applications
- Clean the surface thoroughly and sand
- Damaged area must be dry and free of dust and grease
- Clean undercoat with ColorMatic silicone remover no. 174 469
- Shake the can well for 2 minutes
- Carry out spray test
- Do not use on thermoplastic undercoats!
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of July 23, 2010
This release replaces all eventually earlier issued versions.