Technical Information Repair Spray
Physical and chemical data
- Basis of the binder: acrylate co-polymeres
- Colour: white
- Smell: solvent
- Degree of gloss (at measurement angle 60° acc. to DIN 67530):
matt, 5-10 gloss units - Efficiency:
Depending on consistence and color of the ground:
400 ml are sufficient for approx. 1,0 m² - Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 10 minutes
Dry to touch: after approx. 30 minutes
Cured: after approx 2 hours
Can be overworked after appox. 30 minutes - The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
- Temperature resistance: 80°C
- Storage stability:
10 years if appropriate storage provided (=10° - 25°C, relative air humidity of max. 60%) - Size: aerosol cans, maximum nominal volume 400 ml
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using instructions
The most DUPLI-COLOR spray paints have a so-called no-spray ring or a tamper-proof cap. This is to avoid unauthorized use. Please see the corresponding advises on the cap or on the label.
Before use, carefully read and observe the warning texts on the label!
Application
- Remove dirt, fat, oil and rust.
- Cover areas not to be painted.
- Shake the can vigorously for approx. 2-3 minutes.
- Spray from a distance of approx. 25 - 30 cm.
- Test spray to check compatibiliy at an invisible spot.
- Apply Repair Spray in several thin cross-coats.
- Coatable with synthetic and acrylic lacquers.
- Do not spray over synthetic paints
Tips for spray painting
Protect the object and the surrounding area from spray mist. When painting small areas it is recommended that a piece of card is used as a mask, with a hole cut in it slightly larger than the area to be sprayed. The mask should be held 1 to 2 cm from the surface. With this method, the mainly part of the spray mist is brought under control. It recommends to mask parts not to be lacquered, to protect the surrounding against the spray mist.
The aerosol can should have room temperature.
Temperature should range between +10°C and +25°C, max. air humidity 60 %.
Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of July 20, 2016
This release replaces all eventually earlier issued versions.
