Technical Information Rust Protective Primer
Physical and chemical data
- Basis of the binder: Alcyd resin
- Colour: red brown
- Smell: solvent
- Degree of gloss (at measurement angle 60° acc. to DIN 67530):
not relevant - Efficiency:
ca. 95 ml per m²
that means per 250 ml can: 2.5 - 3 m²
per 750 ml can: 7.5 - 9 m² - Drying time (at 20°C, 65% relative air humidity):
Surface-dry after approx. 4-6 hours
Coatable after 24-36 hours
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Cleaning of tools: immediately after use with brush cleaner
- Storage stability:
5 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Do not store below 5°C - Size: metal tins 250 ml and 750 ml
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Preparation of the ground:
- The surface has to be dry, clean and free from fat and rust.
- Zinc-plated surfaces should be cleaned with a zinc cleaner or a household-cleaner (e.g. spirits auf ammonia).
- Remove old flaking paintings which are not bearing.
- Grind and clean good maintained coatings, then make a test of compatibility
Painting:
- Before application, always carefully stir up the paint.
- Temperature of the object and surrounding temperature should be at least +7°C.
- Brush, roll or spray (adjust to spray viscosity)
- Prime coat with this primer.
- Final coat with a undiluted synthetic paint.
- Before you apply a final coat, slightly sand and clean the ground.
- Cleaning of tools immediately after use with a brush cleaner.
- Dillutable: with universal thinner.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of April 10, 2018
This release replaces all eventually earlier issued versions.