Technical Information Interiour Dispersion
Physical and chemical data
- Basis of the binder: synthetic dispersion
- Colour: white
- Smell: neutral
- Degree of gloss (at measurement angle 60° acc. to DIN 67530):
satin matt - Efficiency:
approx. 10 litre are sufficent
wood chip wall paper white coated - 55 m²
wood chip wall paper uncoated - 45 m²
Smooth plaster - white coated - 65 m²
Smooth plaster - uncoated - 45 m²
Rough plaster - white coated - 45 m²
Rough plaster - uncoated - 35 m² - Drying time (at 20°C, 65% relative air humidity):
surface dry after appox. 4-6 hours
re-coatable after approx. 8 hours
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Best working temperature and object temperature:
Object and working temperature should not be below 5°C. - Cleaning of tools: immediately after use with water
- Storage stability:
2 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Store frost-free - Size: 10 litre plastic buckets
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before coating:
- Cover floors and furniture with a foil.
- Mask off windows and door frames with a masking tape.
- Test the subsoil - it must be firm, dry, clean and stable.
- In case it changes colour to dark during the test with a humid sponge, a primer is necessary.
- Old paintings of glue-bound distemper and chalking surfaces must be completey washed off.
- If necessary, prime with a deep ground.
Coating:
- The colour is ready-to-use and has only to be stirred up carefully.
- It should not be worked if object and working temperatures are below 5°C.
- Can be brushed, rolled or sprayed airless.
- Paint first the ceiling, then the walls.
- In order to avoid visible edges, begin at the window and brush away from the light.
- Work on connected areas without break as a whole.
- In working breaks wrap brush and roller tightly with a plastic foil.
- After work, clean the tools with warm water.
- This colour can be overcoated after 8 hours.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of February 8, 2018
This release replaces all eventually earlier issued versions.