Technical Information Exteriour Dispersion
DUPLI-COLOR Exteriour Dispersion has low odour and is pleasant to work with. The painting stands out by good coverage, enormous efficiency and adherence. It is weather- and abrasion resistant.
Possible substrates: masonry, concrete, chalk und synthetic plasters, cement, wallpapers, dispersion coatings.
Physical and chemical data
- Basis of the binder: acrylate dispersion
- Colour: white
- Smell: neutral
- Degree of gloss (at measurement angle 60° acc. to DIN 67530):
satin matt - Efficiency:
approx. 7 m² per litre - Drying time (at 20°C, 65% relative air humidity):
surface dry after appox. 2 hours
re-coatable after approx. 4 hours
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Best working temperature and object temperature:
Object and working temperature at least 5°C. - Cleaning of tools: immediately after use with water
- Storage stability:
2 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Store frost-free! - Size: 5 litre and 10 litre plastic buckets
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before coating:
- Mask off windows and door frames with a masking tape.
- Test the subsoil - it must be firm, dry, clean and stable.
- Remove chalk and mineral paintings mechanically.
- Wash off carefully glue-bound distemper
- Strong absorbant and sanding substrates should be primed with a substrate stabilizer.
- 1 - 2 paintings depending on ground and wear
Coating:
- The colour is ready-to-use and has only to be stirred up carefully.
- Can be brushed, rolled or sprayed airless.
- Can be diluted with max 10 % water.
- Work on associated areas without breaks and as a whole.
- During working pauses wrap tightly brush or roller.
- After working clean the tools with warm water.
- This paint can be re-coated after 4 hours.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of March 26, 2018
This release replaces all eventually earlier issued versions.
