Technical Information Renovation Paint RAL 9010
DUPLI-COLOR Renovation Paint RAL 9010 is for the protection and decoration of interior wall and ceiling surfaces. It is suitable for the painting of diferent types of mineral plasters, fibre-cement plates, concrete, plaster-cardboard plates, wall papers from glass fibres, wall papers with relief and old coatings.
Physical and chemical data
- Basis of the binder: acrylate dispersion
- Colour: white
- Degree of gloss (acc. to DIN 13300):
matt - Efficiency:
approx. 8-10 m² per litre (one coat) - Drying time (at 20°C, 65% relative air humidity):
the coating is dry and suitable for overcoating after 4-6 hours
The drying time depends on surrounding temperature, air humidity and absorpitivity of the ground. - Best working temperature and object temperature:
min. +5°C - Cleaning of tools: immediately after use with water and a detergent, if necessary
- Storage stability:
2 years if appropriately stored (=10°-25°C, relative air humidity of max. 60%) in the unopened original container.
Store frost-free - Size: 10 litre plastic buckets
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before coating:
- Cover floors and furniture with a foil.
- Mask off windows and door frames with a masking tape.
- Test the subsoil - it must be firm, dry, clean and stable.
In case it changes colour to dark during the test with a humid sponge, a primer is necessary. - Old paintings of glue-bound distemper and chalking surfaces must be completey washed off.
- If necessary, prime with a deep ground.
Coating:
- The colour can be diluted with 5 - 10 % water.
- It can be tinted with max. 3 % pigment pastes.
- The colour has to be stirred up carefully.
- Can be brushed, rolled or sprayed airless.
- Paint first the ceiling, then the walls.
- In order to avoid visible transitions, start at the window and paint off the light.
- Work on associated areas without breaks and as a whole.
- During working pauses wrap tightly brush or roller.
- After working clean the tools with warm water.
- This paint can be re-coated after 4 - 6 hours.
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of September 13, 2018
This release replaces all eventually earlier issued versions.
