Technical Information Plastic Spray
ColorMatic kunststoflak vergemakkelijkt het snel en eenvoudig coaten van grotere oppervlakken dankzij de uitstekende vloei, professionele breedstraalverstuiving en hoge opbrengst. De pigmentatie is speciaal samengesteld om mengen en kleuraanpassing te vergemakkelijken. Specifieke additieven zorgen voor een goede directe hechting op de kunststof grondlaag en een snelle droogtijd.
Toepassing:
Ideaal voor spotrepair en het overspuiten van onderdelen.
Physical and chemical data
- Basis of binder: Acrylic combination
- Colour: Colour specific
- Smell: solvent
- Efficiency:
Depending of consistence and colour of the substrate 400 ml are sufficient for approx. 0,8 - 1,0 m² - Substrate:
Plastics: PP, PP/EPDM, ABS - Drying (at 20°C, 50% relative air humidity):
Dust-dry: after 8 - 15 minutes
Touch-dry: after 30 - 45 minutes
The drying time is depending on the ambient temperature, air humidity and the painted layer - Temperature resistance: to 110 °C
- Storage stability:
10 years if appropriate storage provided (=10° - 25°C, relative air humidity of max. 60%) - Gebinde:
Aerosol cans, maximum nominal volume 400 ml - VOC-value: 241,2 g
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Application
- clean surfaces to be painted thoroughly with ColorMatic antistatic Plastic Cleaner antistatic no. 190261, then sand
- The area must be dry and free of grease and dust
- Shake can vigorously for 2 minutes
- Carry out spray tests
- for optimum adhesion, clean with ColorMatic Plastic Cleaner antistatic, no. 190 261, or ColorMatic Leather and Plastic Cleaner, no. 130 700Hechtprimer voor kunststof
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
Order information
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of August 6, 2019
This release replaces all eventually earlier issued versions