Technical information Insulating Primer
Fast drying insulating primer spray for interior and exterior application on the basis of synthetic resins, with excellent isolation and barrier effect against many different types of stains (especially water stains) on mineral-based substrates (plaster etc.), wood and concrete. Can be painted over with all emulsion paints, alkyd-based, water-based and acrylic paints; not with two-component paints. Adjustable spray cone width (horizontally and vertically).
Application area: Ideal when fastness and mobility are the primary considerations.
Physical and chemical data
- Basis of binder: Synthetic resins
- Colour: white
- Smell: solvent
- Efficiency:
Depending on consistence and colour of the ground:
400 ml are sufficient for approx. 1,0 - 1,5 m² - Substrate:
Wood, metal and on minerally substrates like concrete, stone, plastering etc. - Drying time (at 20°C, 50% relative air humidity):
Dust-dry: 6 min
Touch-dry: 60 min
Re-coatable: 60 min
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat. - Temperature resistance: to 110°C
- Storage stability:
10 years if appropriabte storage provided (=10°-25°C, relative air humidity of max. 60%) - Size:
Aerosol cans, maximum nominal volume 400 ml - VOC-value: 254,9 g
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
- Clean surfaces to be painted thoroughly with DUPLI-COLOR Degreaser Spray art.no. 478376, then sand
- The area must be dry and free of dust and grease
- Shake can well for 3 minutes
- Carry out spray test
- 2-3 coats
- Wear an appropriate respirator (type A2/P3)
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of February 16, 2018
This release replaces all eventually earlier issued version.
