Technical Information Forestry Marking Spray Neon
Distein Forestry Marking Spray is to be used for marking of trees, wood and stone also.
Distein Forestry Marking Spray with it’s reliable adhesion on wet surfaces is weather- and water-proof.
The 360° valve enables to spray the forestry marking paint in all sites and directions, because of the special valve there is also a finer lettering possible.
Quality and properties
- Weather-proof, good adhesion on wet surfaces
- Ideal opacity and fluorescence
- Frost-proof till -20° C
- Minimal drizzle
- 360° valve for marking in all sites and directions
- The special nozzle is perfect for flat spraying and wood marking
- High fertility
- Environment-neutral propellant, without CFC
- Without Toluene
- Without cadmium, lead and other heavy metal
- Easy colour-recognition with patented coloured donut
- Application is possible with metal spray handle
Physical and chemical data
- Colours:
Neon-red, Neon-orange, Neon-yellow, Neon-blue, Neon-green - Binder:
Acrylat - Depending on surface and colour 500 ml are sufficient for approx. 3-4 m²
- Drying:
Dust-dry: after 10 minutes
Dry to touch: after 30 minutes
Fully dried: after 24 hours - Disposal:
Only the completely empty can should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse". - Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%) - Container:
Maximum nominal volume = 500 ml
Environment and labelling
Environmentally sound: European Aerosols is committed to apply formulations without restricted or critical ingredients and to achieve best possible performance. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
- Before use, shake can well for 2 minutes.
- Spray to test colour and compatibility on an inconspicious area.
- Distance approx 10-15 cm
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.
As of November 07, 2014
This release replaces all eventually earlier issued versions.
