Technical Information 1K Spray Putty
ColorMatic 1K Spuitplamuur biedt een extreem hoge vulkracht en duurzaamheid. Het is ideaal voor het egaliseren van grote oneffenheden op geschuurde onderlagen en biedt een zeer goede hechting op polyesterplamuur, kunststoffen en metalen.
Toepassing:
Ideaal voor spotrepair en het overspuiten van onderdelen.
Physical and chemical data
- Basis of binder: Acrylic resin
- Colour: beige
- Smell: solvent
- Efficiency:
400ml are sufficient for approx. 1,25 - 1,75 m² - Substrate:
blank sheet steel, sanded, priming of spare parts, sanded, cured paintings, sanded, polyester substrates, sanded - Drying time (at 20°C, 50% relative air humidity):
Dust dry: 5 min
Dry to touch: 15-20 min
Sandable: 60 min
Hard dry: 60 min
Coatable: 60 min - Temperature resistance: to 110°C
- Storage stability:
24 month if appropriate storage provided (=10° - 25°C, relative air humidity of max. 60%) - Size:
Aerosol cans, maximum nominal volume 400 ml - VOC-value: 240,1g
Disposal and labelling
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by European Aerosols comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
- Remove all rust from damaged area and sand
- Damaged area must be dry and free of dust and grease
- Shake the can well for 2 minutes
- Carry out spray test
- Attention: after sanding thouroghly clean surface with water-based cleaner. Don't use solvent-based cleaner.
- For professional use only
- Wear an adequate respirator (we recommended type A2/P3)
Disclaimer of liability
This application-technological information is given to the best of our knowledge. The notes mentioned herein are, however, non-binding and do not exempt you from own tests to see whether the products supplied by us are suitable for your special application. The use and processing is beyond our control and therefore exclusively in the responsibility of the user. European Aerosols is let off the liability, unless the liability-based incident is caused by a fault incurred to European Aerosols.